Why does my speaker pop when I turn it on?

Speaker crackling is almost always caused by a connection problem. The first thing to do is to check the wire connections between the amplifier and the terminals on the speaker itself. If the wire has a tendency to get moved around, perhaps by a cat or dog, it’s a possibility something has come loose.

How do I stop my turntable humming?

GROUND LOOP The cables included with your turntable include a ground cable. The first step to fixing a turntable hum is connecting this cable to the grounding terminal on the back of your turntable. Tighten the nut down on the cable connector. Repeat these steps on the grounding terminal of your amplifier or speakers.

Why does my Yamaha have low dialogue volume?

I have a Yamaha RXV-377 encountering Low dialogue volume against louder background sound. I tried turning on the Adaptive DRV, but to no effect. Is there something else I should try?

How does a phono preamp work on a turntable?

The way to fix this is to include a phono preamp that transforms the phono level signal to a line level signal. A phono preamp can be a standalone box, or built into the turntable or into the receiver. (Phono preamps are commonly called just preamps in the vinyl jargon.)

How to increase dialogue volume on Yamaha AV receiver?

If wanting to used DRC that would be applied more librally then use Tamaha’s own proprieatary YPAO VOLUME which isn’t dependant upon metadata hints embedded within the content being portrayed. By altering the speaker level to 10db higher than they are supposed to be set, all you’ve done is increase the volume relative to reference by 10db.

What kind of noise does a Yamaha jet make?

This is more of a “WHHHHAAAAA” at speed, the last was more of a “BBBUUUUUUUUURRRRRRR” at speed. Again, volume was the same-ish. Needed about 1/2-2/3 volume on the stereo in each to overcome the engine. Having a conversation on plane wasn’t really easy in either.

I have a Yamaha RXV-377 encountering Low dialogue volume against louder background sound. I tried turning on the Adaptive DRV, but to no effect. Is there something else I should try?

Can a phono output be connected to a turntable?

If it has, it is perfectly ok to connect your turntable PHONO output to the PHONO input on the receiver. If neither your turntable or receiver has a built-in preamp, you’ll have to get hold of a standalone preamp that connects between the PHONO output on your turntable and one of the line level inputs on your receiver (LINE, AUX, CD, TAPE, etc.)

How can I increase the volume on my Yamaha AV receiver?

By altering the speaker level to 10db higher than they are supposed to be set, all you’ve done is increase the volume relative to reference by 10db. THe receiver is now incorrectly calibrated. You could have achieved exactly the same result by simply increasing the master volume by 10db.