Why is my receiver saying protect?

PROTECT or PROTECTOR is flashing in the display of the home audio device. If there has been an electrical surge or power outage, then the internal surge protection inside the home audio device may have been triggered to protect the device from the surge. This is normal.

What is S Protect mean on a LG receiver?

If what appears spells “S-PROTEC” it means the unit has shut down in order to prevent damages to the amplifier component. Issue. Amplifier protection arises the moment the device detects potential harm to this very important circuitry component from a voltage fluctuation.

Is there any way to reset receiver protection mode?

Haventran any wires plugged it in , powered on and shuts off in 2 seconds. Checked compositors and and burns on the board with no signs of damage. Don’t have a meter right now. I know there’s certain resets you can do but not sure what I’m looking for yet. Also software update but haven’t got that far.

How to reset a pioneer a / V receiver from protection mode?

Thanks again. I have an Onkyo TX-DS575X that is apparently in protection mode…any ideas on how to reset it? unplug it and hold the power buton for 5 seconds.i dunno if that’ll work cuz its instructions on how to reset a Kenwood vr-6070 but it might, try it.

What to do if your Sony receiver is in Protector mode?

It basically said open it up, clean out the dust, and then disconnect and reconnect every connector you can get your hands on. I’d already vacuumed out the inside (which wasn’t really dusty anyway), but proceeded to disconnect and reconnect every connector in there, and there’s a BUNCH.

Why is my speakers going to protect mode?

It would only come on for a few seconds and then resort to Protect mode. Here’s what I have checked, all resulting in the same outcome, only going to Protect mode. I checked all speakers, removing each until none were connected to the receiver. Power up, right to Protect mode. I followed the recommended reset procedure with no change.

Thanks again. I have an Onkyo TX-DS575X that is apparently in protection mode…any ideas on how to reset it? unplug it and hold the power buton for 5 seconds.i dunno if that’ll work cuz its instructions on how to reset a Kenwood vr-6070 but it might, try it.

What’s the up with my Receiver going into protect mode only?

Last Fall, out of the blue my Denon AVR-589 5.1 receiver stopped working. It would only come on for a few seconds and then resort to Protect mode. Here’s what I have checked, all resulting in the same outcome, only going to Protect mode. I checked all speakers, removing each until none were connected to the receiver.

When to reset the internal surge protection circuit?

If there has been an electrical surge or power outage, then the internal surge protection inside the home audio device may have been triggered to protect the device from the surge. This is normal. To reset the internal surge protection circuit unplug the AC power cord from the wall for at least 30 minutes.

It would only come on for a few seconds and then resort to Protect mode. Here’s what I have checked, all resulting in the same outcome, only going to Protect mode. I checked all speakers, removing each until none were connected to the receiver. Power up, right to Protect mode. I followed the recommended reset procedure with no change.