Why is my stereo blinking protect?

Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections.

Is there a Sony stereo receiver flashing a ” protector ” message?

Sony STR AV 710 receiver flashes protector In red is there a Sony STR AV 710 receiver flashes protector In red is there a fuse somewhere …  read more Aric Technician 54,632 satisfied customers I have a Sony FM/AM receiver STR DE 535, (performing very I have a Sony FM/AM receiver STR DE 535]

How to reset the Protector on a Sony stereo?

Sony stereo receiver flashing a “protector” message. How to reset? Customer Question I have a Sony stereo… I have a Sony stereo receiver that seems to be stuck flashing a “protector” message…can I reset this? Submitted:9 years ago. Category: Consumer Electronics Show More Show Less Ask Your Own Consumer Electronics Question

Why does my protect or protector keep flashing?

PROTECT or PROTECTOR is flashing in the display of the home audio device. NOTE: If model-specific information is needed to complete any of these steps, refer to the instruction manual with the product. Manuals are posted on your model support page.

Why is the word protector flashing on my speakers?

If the words PROTECTOR and PUSH POWER appear in alternating sequence on the display of your home audio device, or if the word PROTECT or PROTECTOR appears, there may be an external speaker issue or connection issue that is triggering the protection circuit.

How to fix Sony receiver ” protect ” mode?

Sony receiver “protect” mode? I have a Sony STR-D665 receiver, that states “protect” on the display about 2 seconds after turning it on, and it won’t do anything. Does anyone know how to fix this?

Why does my Sony surround sound receiver flash protector?

My goodness the internet is great. I was about to throw out a Sony surround sound receiver I’ve had for years because it would flash “PROTECTOR” on the display after being on for a few seconds, and I’d tried everything I could think of (cleaning, making sure no bits of wire in speaker posts, leaving off for hours or days, etc.).

Why does my Sony STR D665 say protect?

I have a Sony STR-D665 receiver, that states “protect” on the display about 2 seconds after turning it on, and it won’t do anything. Does anyone know how to fix this? It does it regardless of anything connected to it or not. That is usually caused by a short in one of the speakers.

What does protector mean on a Sony stereo?

“Protector” is an indicator that there are either shorted speaker outputs inside the unit, a shorted speaker wire, or a blown speaker connected to the unit. Unplug the unit from AC power for 30 minutes, and disconnect all of the speakers and other associated equipment.